Want to try it? Follow the directions and photos below!.
Supplies:
Card Base of Whisper White Thick Cardstock 5 1/2″ x 8 1/2″
Bottom (Rich Razzleberry) Mat 3 1/4″ x 4 3/4″
Whisper White (reg) Mat for Stamping: 3″ x 4 1/4″
Stamps
Inks
Dimensionals
Ribbon
 | 1.Start by stamping an image that has some height to it and add a sentiment. |
2.Next you will cut this stamped image into three pieces. Trim a 1/2″ piece of the bottom and then trim a 3/4″ piece off the remaining piece. You will now have three pieces as you see in the photo. |  |
 | 3. Add dimensionals to the back of the pieces as shown. Be sure to leave a border at the bottom edge of the top piece without dimensionals as well as the top edge of the second piece. This will allow room for the ribbon to lay between the two pieces. |
4. Adhere the top and bottom pieces first leaving a small border around them. Then fit the middle piece in the center to ensure equal spacing above and below it. |  |
 | 5. Slide the ribbon into the space between the top piece and second piece of your stamped image. Wrap it around the back and adhere as shown in the photo. |
6. Tie a bow and adhere it to the front with a glue dot. On the card on the left (at top of post) I stamped a background on the whisper white card base. I used Smokey Slate and stamped off on a piece of scrap paper to get a lighter color of ink. For the card on the right, I included a piece of patterned paper on the card base first- cut 5 1/4″ x 4″. Next adhere this entire panel to your card base. Don’t forget to stamp a little something inside your card and on the envelope as well! |  |
You can see all the supplies I used and shop at my online store by clicking on any of the pictured items at the end of the post..
Happy Chat’n’Crafting to You!
Lorraine
Leave a Reply